|
[Sponsors] |
May 6, 2016, 04:48 |
Meshing with OpenFOAM: errore in checkMesh
|
#1 |
New Member
Join Date: May 2016
Posts: 28
Rep Power: 10 |
Hello everybody.
I'm quite new in OpenFOAM since I have been using it for some months, and I registered a problem in using snappyHexMesh. I am trying to mesh a domain around an airfoil in order to simulate compressible flows, but when I check mesh with checkMesh utility there's this errore message: ***Number of edges not aligned with or perpendicular to non-empty directions: 56148 <<Writing 83645 points on non-aligned edges to set nonAlignedEdges At the following link you can find my case: Mesh Thank you in advance for everyone is going to reply and help me. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM Training Beijing 22-26 Aug 2016 | cfd.direct | OpenFOAM Announcements from Other Sources | 0 | May 3, 2016 04:57 |
OpenFOAM v3.0.1 Training, London, Houston, Berlin, Jan-Mar 2016 | cfd.direct | OpenFOAM Announcements from Other Sources | 0 | January 5, 2016 03:18 |
OpenFOAM Aircraft dynamic meshing | shereez234 | OpenFOAM Running, Solving & CFD | 0 | October 25, 2015 14:58 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
[blockMesh] CheckMesh error using a tutorial from OpenFOAM 114 with openFOAM 13 | martapajon | OpenFOAM Meshing & Mesh Conversion | 7 | January 21, 2008 12:52 |