|
[Sponsors] |
Problems on "purgeWrite" and "writeCompression" for probe |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 17, 2019, 22:43 |
Problems on "purgeWrite" and "writeCompression" for probe
|
#1 |
Member
DongHo
Join Date: Jul 2013
Posts: 51
Rep Power: 12 |
Dear. Foamers
I am trying to use "purgeWrite" and "writeCompression" for probe on V4.0 or 4.1, though.. That did not work for probes under functions (Even though they were correctly working for general output file control). A part of my controlDict is as below. I will appreciate it if you can check it and respond me. Thanks. ... application pisoFoam; startFrom startTime; startTime 0; stopAt endTime; endTime 1; //2200; //80; //60; //30; //20; //2; deltaT 5e-03; //1e-03; //1e-04; //0.005; writeControl timeStep; //adjustableRunTime; writeInterval 10; //0.001; //20; //10; //20; //100; purgeWrite 5; //0; writeFormat ascii; //binary; writePrecision 6; writeCompression compressed; //off; timeFormat general; timePrecision 6; runTimeModifiable true; functions { probes { type probes; libs ("libsampling.so"); writeControl timeStep; writeInterval 10; purgeWrite 5; writeCompression compressed; fields ( U p UMean pMean ..... ..... ..... |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[mesh manipulation] Problems with rotational cyclic boundaries | TReviol | OpenFOAM Meshing & Mesh Conversion | 8 | July 11, 2014 03:45 |
[ICEM] Flow channel meshing problems | StefanG | ANSYS Meshing & Geometry | 19 | May 15, 2012 06:44 |
Two-phase air water flow problems by activating Wall Lubrication Force | challenger85 | CFX | 5 | November 5, 2009 05:44 |
Help required to solve Hydraulic related problems | aero | CFX | 0 | October 30, 2006 11:00 |