|
[Sponsors] |
how to make a mesh decomposition again when using interFoam/dynamicRefineFvMesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 27, 2021, 07:08 |
how to make a mesh decomposition again when using interFoam/dynamicRefineFvMesh
|
#1 |
New Member
jianfeng zou
Join Date: Feb 2013
Posts: 6
Rep Power: 13 |
Dear all,
I'm working on OpenFOAM2012. I'm using a interFoam with dynamicRefineFvMesh to compute a gas/fluid interface. The mesh is decomposed at t=0 and the problem is solved for some time, like t=t0. To achieve a good load balance, I want to make a mesh decomposition again. The function 'redistributePar' has been tested in my study, but I failed to achieve a new mesh decomposition with right cells and interpolated solution on them. Will anyone tell me the right steps to work with 'redistributePar'? Thanks very much. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
foam-extend-4.1 release | hjasak | OpenFOAM Announcements from Other Sources | 19 | July 16, 2021 05:02 |
GeometricField -> mesh() Function | Tobi | OpenFOAM Programming & Development | 10 | November 19, 2020 11:33 |
compiling firefoam | Farshad_Noravesh | OpenFOAM | 27 | December 24, 2012 04:21 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
[ICEM] How to make Pereodic Tetra mesh? | ale-kc | ANSYS Meshing & Geometry | 6 | November 15, 2010 14:23 |