|
[Sponsors] |
December 2, 2009, 08:34 |
Setting the amount of water
|
#1 |
Member
Dennis Rown
Join Date: Oct 2009
Posts: 51
Rep Power: 16 |
Hello!
I have managed to simulate water entering a 3D cube from the upper side. I did this by specifying 0/alpha1 for the upper side of the cube as: type inletOutlet; value uniform 1; inletValue uniform 1; The water flows into the cube. But how can I control how many liters or m³ per minute are released into the cube? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help for setting 3D boundary condition in compressing water vapor | sogolf | FLUENT | 0 | September 27, 2009 15:05 |
Boundary condition setting for water hammer proble | yizhou | FLUENT | 1 | October 12, 2007 12:16 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
uptodate water distribution network | fredius,magige,tanzanian,(e.a) | Main CFD Forum | 0 | January 27, 2002 07:10 |