|
[Sponsors] |
December 4, 2009, 08:44 |
blockMesh problem
|
#1 |
Member
Dennis Rown
Join Date: Oct 2009
Posts: 51
Rep Power: 16 |
Hello!
I have a problem with blockMesh. I modelled a tube with a hole on an upper side where water (alpha1 = 1) flows in. The problem is, when I change the z-values of the mesh to a high number, the water disappears from the simulation. As in the example picture I attached it works for the z value "3" on the outer blocks. When I choose a higher z-value, water disappears. What can cause this? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
Incoherent problem table in hollow-fiber spinning | Gianni | FLUENT | 0 | April 5, 2008 10:33 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |