|
[Sponsors] |
December 30, 2009, 22:20 |
Inlet and Outlet w/ Single Boundary
|
#1 |
Senior Member
|
After mesh generation, i would like to change the angle of attack of the flow field. This is doable with a diamond or square mesh with separate outlet and inlet boundaries.
However to increase mesh quality i would like to use a "C" mesh or an "O" mesh. The curved boundaries however demands for a single boundary to handle both inlet and outlet. Can open foam do this? What would be the boundary type/name? Every bit helps, Thanks guys! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 20, 2010 15:45 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 06:18 |