|
[Sponsors] |
![]() |
![]() |
#1 |
Senior Member
Andrea Ferrari
Join Date: Dec 2010
Posts: 319
Rep Power: 16 ![]() |
Hi all,
is it possible switching off the non-linear term in interFoam?. Is it enough just comment out this line? // + fvm::div(rhoPhi, U) in UEqn.H. Because i did it but i got some strange behavior at the interface and i was thinking that maybe it is not consistent with the rest of implementation. best regards andrea |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
Andrea Ferrari
Join Date: Dec 2010
Posts: 319
Rep Power: 16 ![]() |
Any comment on this? For my types of applications (very low velocities) negletting the non-linear term is a usual assumption so i wondering if it's feasible switch it off.
best andrea |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Switching between different schemes | Mr. Matti | Main CFD Forum | 0 | June 4, 2010 06:09 |
Modelling fluid inertia | abdulnasr | FLUENT | 0 | July 1, 2009 10:57 |
Negligible Inertia and Convective Heat Transfer | Miky1020 | CFX | 2 | June 9, 2009 20:16 |
3D axis switching in a turbulent jet | fluidsguy1001 | FLUENT | 0 | November 6, 2007 17:18 |
Inertia coefficient. | Ard | FLUENT | 0 | February 20, 2005 21:48 |