|
[Sponsors] |
September 24, 2012, 11:32 |
Slicing with .stl surface
|
#1 |
Senior Member
Lance
Join Date: Mar 2009
Posts: 669
Rep Power: 22 |
Hi,
Is it possible to slice an unstructured grid with a .stl surface imported into paraview? The .stl surface is 3D and very complex and cannot be approximated with a plane or box or anything else. Any suggestions are appreciated! |
|
October 23, 2014, 08:49 |
|
#2 |
New Member
Mark Herskind
Join Date: Oct 2010
Posts: 12
Rep Power: 15 |
Did you make any progress on this?
I have a similar problem, so I would be very interested in your solution.. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Using .stl - Surface for Average Pressure / Mass Flux / ... | CellZone | OpenFOAM Pre-Processing | 2 | May 4, 2016 02:25 |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
[snappyHexMesh] Add additional boundary layers to complex stl surface | tobijingles | OpenFOAM Meshing & Mesh Conversion | 1 | October 26, 2011 10:45 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |