[General] Data along the surface

Praveen_krish · March 5, 2023, 23:53

Hey, I have a flow.vtu file ( picture attached). It has the data of CFD simulation over a Bicone structure. In the plane with origin (0,0,0) and normal (0,0,1) I would like to get the graph of pressure on the upper half and lower half (usually windward and leeward sides if there was AoA) vs the x coordinates. Which filter can I use to get the above data? I have heard that a Plot over the intersection of curves can be used but I don't know how to use that. Please let me know the steps involved to get the data.

lvl99 · June 21, 2023, 05:27

I'm not sure if I understood correctly, but I would say that you could use the plot over line filter defining the line over the parts of the surface you're interested in, then you could either plot the pressure as a function of the line's length or of x if I remember correctly

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] gmshToFoam generates patches with 0 faces and 0 points	Simurgh	OpenFOAM Meshing & Mesh Conversion	4	August 25, 2023 07:58
OpenFOAM error	Vinay Kumar V	Main CFD Forum	0	February 20, 2020 09:17
Cluster ID's not contiguous in compute-nodes domain. ???	Shogan	FLUENT	1	May 28, 2014 15:03
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem	Attesz	OpenFOAM Meshing & Mesh Conversion	12	May 2, 2013 10:52
saving Transient/Unsteady data of multiple surface integrals in single file	ankur gupta	FLUENT	0	February 22, 2012 13:59

June 21, 2023, 05:27		#2
lvl99 New Member Luis VL Join Date: Jul 2022 Location: Toulouse Posts: 18 Rep Power: 3	I'm not sure if I understood correctly, but I would say that you could use the plot over line filter defining the line over the parts of the surface you're interested in, then you could either plot the pressure as a function of the line's length or of x if I remember correctly