|
[Sponsors] |
March 22, 2006, 00:01 |
Running paraFOam
|
#1 |
Guest
Posts: n/a
|
HI
I am just starting to learn OpenFoam and have been going through the tuts from the user guide. When I try to view the mesh for the case cavity (2.1.2 of the User Guide) I get a window which looks very different from Figure 7.1. The current window has 3 tabs labelled: General, annotate and camera instead of parameters, display and information. I had problems running paraFoam earlier (ie segmentation fault, line 57 in paraview) so I commented that entire file and finally got it to open. It's just that the windows doesn't look the way it should. SHuo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error problem while running sadia d lts tutorial | kane | OpenFOAM Running, Solving & CFD | 2 | May 26, 2018 03:38 |
License trouble: ANSLIC_ADMIN, FLEXlm not running, but two lmgrd processes running! | dancoz87 | ANSYS | 17 | November 14, 2016 01:10 |
paraFoam "Fatal Error" on Debian Wheezy/Sid | ned800 | OpenFOAM Installation | 3 | October 24, 2012 11:26 |
[OpenFOAM] ParaFoam Error | jblucca | ParaView | 1 | June 28, 2007 02:37 |
[OpenFOAM] Both paraview and paraFoam crash on Redhat Linux WS v4 64bit | sek | ParaView | 4 | August 17, 2006 16:26 |