|
[Sponsors] |
November 7, 2010, 09:08 |
reload data paraFoam 3.8.0
|
#1 |
Member
Arnout
Join Date: Nov 2010
Posts: 46
Rep Power: 15 |
Hi!
I'm trying ParaView 3.8.0 on linux (opensuse). Before it was possible to reload the case after new calculations (done with paraview open) by clicking "update GUI". Looks like it is not working anymore. I have te re-read the case before new data is viewed. Are more people seeing the same and maybe found a work around? Arnout |
|
December 10, 2010, 05:06 |
|
#2 |
Senior Member
Bernhard
Join Date: Sep 2009
Location: Delft
Posts: 790
Rep Power: 21 |
I'm encountering the same 'problem', did you find a work-around yet?
|
|
December 10, 2010, 11:24 |
|
#3 |
Member
Arnout
Join Date: Nov 2010
Posts: 46
Rep Power: 15 |
No, but sometimes it's working, sometimes not. Just clicking the time up button is working sometimes... Good luck!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
How to setup a simple OpenFOAM cluster? | TommiPLaiho | OpenFOAM Installation | 3 | October 27, 2013 15:15 |
[General] Using Python in Openfoam in-built paraFoam (paraView 3.8.0) | Man Yue | ParaView | 6 | November 30, 2012 06:57 |
[OpenFOAM] How to tell paraFoam what data to use | bastil | ParaView | 1 | February 13, 2009 19:19 |
[OpenFOAM] Multiple independant data sets in paraFoam | christian | ParaView | 1 | August 27, 2007 12:30 |