small size holes simulation -- CFD Online Discussion Forums

October 16, 2001, 20:43	small size holes simulation	#1
brian ko Guest Posts: n/a	Now I meet a problem confused me. I establish a blockage(0.2m x 0.2m x 0.07m)that top surface has high temp. glass inflow and bottom surface has about 1200 small holes(each hole diameter is less than 0.002m)to outflow. When I finish my model and run it. The program shut down. One reason may be my computer ram(256MB)lack . Another reason may be holes too small that will grown too many small grid region. So who can tell me "Phoenics can run a model in that has small size model"?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to model many small holes in a large domain?	Bryan Woods	FLUENT	3	February 5, 2009 19:34
Urgent: 3D hollow pipe with small holes at faces	ASHOK	CFX	4	February 3, 2009 16:25
Simulating inlet consisting of many small holes	christian	OpenFOAM Running, Solving & CFD	3	October 15, 2008 02:56
Could small size particles be treated as gas?	Nanazhu	FLUENT	0	July 20, 2008 23:44
Gambit: mesh size to small???	Ralf Schmidt	FLUENT	1	January 28, 2006 01:26

All times are GMT -4. The time now is 07:38.