|
[Sponsors] |
July 16, 2003, 03:43 |
how to set a block with phoenics3.4
|
#1 |
Guest
Posts: n/a
|
I have been working hard to the numerical simulation of combustion with BFC. Lately, to my painful, I cann¡¯t set a block in the above of nozzle inlet. When I set a block, the iterations(sweeps) end with only 2 sweeps. However,If I substitute 4 plates for block, the solving process is very satisfied. I don¡¯t know why this is? In fact, the subsititute is not accord with the physical model. How to set a block with BFC.? How to modify Q1file?(considering vpor,epor,hpor etc.)
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Block Tridiagonal and Block Bidiagonal solver | Amit | Main CFD Forum | 8 | February 18, 2015 16:53 |
problems with viewing mesh block by block | James | CFX | 0 | January 22, 2008 12:11 |
Block-Block tridiagonal matrix inverse | Abdulhafid Elfaghi | Main CFD Forum | 3 | September 16, 2007 02:55 |
looking for 2D block/multi-block grid generator | phsieh | Main CFD Forum | 0 | October 29, 2003 08:07 |
CFX5 vs PHOENICS3.2 ? | weili | CFX | 0 | July 1, 2001 16:09 |