2 point curve is not made

swtbkim · December 2, 2014, 22:25

I want to make a connector between 1 and 2
I used '2 Points Curves', but the curve is made between 1 and 3, not 1 and 2 as shown in attached figure.

Is there distance limitation or something?
I have no idea..

Thank you.

cnsidero · December 3, 2014, 09:17

When you created the second point, did you try clicking on an existing point? If so, what happened? Can you give some more detail as to what happened when you created the second point.

To my knowledge, there is no distance limitation.

The only thing I can think that might be happening is the first point of the connector was (automatically) constrained to a database. Then when you created the second point, even though it was away from the database, it (automatically) snapped back the closest point on the database. If you're using the Two Point Curves tool the aforementioned shouldn't be happening. This behavior only should occur with the Draw Curves, Line on Database tool.

swtbkim · December 3, 2014, 09:35

Exactly correct!
It works after turning database off(ctrl+shift+F5).

but I can't understand why this happened.. I have never worked without database, and this has never happened.

Thanks a lot, anyway.('anyway' is proper word here?

)

December 3, 2014, 09:35		#3
swtbkim Senior Member Sangwoo Kim Join Date: Jul 2014 Location: Seoul, South Korea Posts: 115 Rep Power: 11	Exactly correct! It works after turning database off(ctrl+shift+F5). but I can't understand why this happened.. I have never worked without database, and this has never happened. Thanks a lot, anyway.('anyway' is proper word here? ) __________________ Best regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ActuatorDiskExplicitForce in OF2.1. Help	be_inspired	OpenFOAM Programming & Development	10	September 14, 2018 11:12
[snappyHexMesh] How to define to right point for locationInMesh	Mirage12	OpenFOAM Meshing & Mesh Conversion	7	March 13, 2016 14:07
[General] 2 datas on one plot	Akuji	ParaView	46	December 1, 2013 14:06
[ANSYS Meshing] Importing Cylinders by Point Data Input with Radii	EphemeralMemory	ANSYS Meshing & Geometry	2	May 31, 2012 13:34
CFX Post: Problems with moving point cloud for changing time steps	spatialtime	CFX	0	December 7, 2009 04:56

December 3, 2014, 09:17		#2
cnsidero Senior Member Chris Sideroff Join Date: Mar 2009 Location: Ottawa, ON, CAN Posts: 434 Rep Power: 22	When you created the second point, did you try clicking on an existing point? If so, what happened? Can you give some more detail as to what happened when you created the second point. To my knowledge, there is no distance limitation. The only thing I can think that might be happening is the first point of the connector was (automatically) constrained to a database. Then when you created the second point, even though it was away from the database, it (automatically) snapped back the closest point on the database. If you're using the Two Point Curves tool the aforementioned shouldn't be happening. This behavior only should occur with the Draw Curves, Line on Database tool.