Boundary conditions in pointwise for Ansys Fluent -- CFD Online Discussion Forums

November 21, 2011, 03:36	[solved]Boundary conditions in pointwise for Ansys Fluent	#1
seasoul New Member wuyu Join Date: Mar 2010 Posts: 27 Rep Power: 16	I did a simple meshing in Pointwise as a start point of my learning. It is half of a pipe. I have chosen the CAE solver as Ansys Fluent, but when I read the case file from Pointwise, it seems there are several inlets, several outlets... I did define the inlet domains (surfaces) together as the inlet in pointwise. Anything need to be done to correct this? I have found a post that mentioned this problem, http://www.cfd-online.com/Forums/ans...onditions.html But it seems the answer is, if I am not wrong, some steps in ICEM CFD. Last edited by seasoul; November 21, 2011 at 22:59.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boundary Conditions for aircraft engine in Fluent 6.3	Tareen	FLUENT	0	July 20, 2011 00:05
PointWise Boundary Conditions	skris2009	ANSYS Meshing & Geometry	1	June 24, 2010 12:42
Gridgen's boundary conditions and Fluent	famarcfd	FLUENT	0	December 12, 2009 10:00
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 04:05
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

All times are GMT -4. The time now is 08:51.