Search Results

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: ghorrocks

Forum: CFX

December 12, 2018, 05:53

Replies: 7

Multiphase Phase Change

Views: 752

Posted By ghorrocks

The solids must not overlap. So if you generate...

The solids must not overlap. So if you generate cylinders in the middle of your domain you must remove those cylindrical regions from the outer region.

Forum: CFX

December 12, 2018, 00:09

Replies: 7

Multiphase Phase Change

Views: 752

Posted By ghorrocks

The easiest way is to define them as separate...

The easiest way is to define them as separate regions in the mesh. So you might be able to do that in your meshing package, or you might need to do it in your solid modelling package depending on...

Forum: CFX

December 11, 2018, 23:47

Replies: 7

Multiphase Phase Change

Views: 752

Posted By ghorrocks

You don't need to do all that stuff if you just...

You don't need to do all that stuff if you just define a mesh region then define that mesh region as a subdomain which you apply your source to.

You should check that your source term results in...

Forum: CFX

December 11, 2018, 05:37

Replies: 7

Multiphase Phase Change

Views: 752

Posted By ghorrocks

Either you have not put enough heat into the...

Either you have not put enough heat into the water to boil it or you have a numerical error which is grossly underestimating the heat transfer. It would detailed analysis of your simulation to work...

Showing results 1 to 4 of 4

Forum Jump

All times are GMT -4. The time now is 10:19.