Search Results

Showing results 1 to 2 of 2
Search took 0.00 seconds. Search: Posts Made By: Gert-Jan

Forum: ANSYS Meshing & Geometry

January 28, 2024, 15:12

Replies: 3

[ANSYS Meshing] Internal solid wall from ICEM not showing on Fluent

Views: 243

Posted By Gert-Jan

It looks like you treat the circle as a thin...

It looks like you treat the circle as a thin surface (Internal Wall). So, you need to set it like that, otherwise ICEM will ignore it.
You need to go to Mesh > Part Mesh Setup. There in the last...

Forum: ANSYS Meshing & Geometry

January 24, 2024, 03:02

Replies: 3

[ANSYS Meshing] Internal solid wall from ICEM not showing on Fluent

Views: 243

Posted By Gert-Jan

I don't know Fluent. I try to avoid it as much as...

I don't know Fluent. I try to avoid it as much as possible.

What can help is to split the geometry in two volumes at the location where your circle (butterfly valve??) is located. Then you get an...

Showing results 1 to 2 of 2

Forum Jump

All times are GMT -4. The time now is 13:22.