Search Results

Showing results 1 to 3 of 3
Search took 0.00 seconds. Search: Posts Made By: Gert-Jan

Forum: ANSYS Meshing & Geometry

February 5, 2024, 05:23

Replies: 5

[ICEM] Inflation layers on inlet

Views: 262

Posted By Gert-Jan

In your case I would apply inflation all over. Or...

In your case I would apply inflation all over. Or at least to a limited extent over the parallel surface, to reduce numer of elelements. Alternatively you set less layers (1?) on the large surface...

Forum: ANSYS Meshing & Geometry

February 5, 2024, 04:38

Replies: 5

[ICEM] Inflation layers on inlet

Views: 262

Posted By Gert-Jan

Normally inflation is applied on walls, not on...

Normally inflation is applied on walls, not on inlets, outlets or interfaces.
In your case you appear to only apply inflation on the inlet of the pipe. Then why not also on the surfaces parallel?...

Forum: ANSYS Meshing & Geometry

February 4, 2024, 14:55

Replies: 5

[ICEM] Inflation layers on inlet

Views: 262

Posted By Gert-Jan

I don't understand the problem. Please share a...

I don't understand the problem. Please share a view from the internal mesh.

Showing results 1 to 3 of 3

Forum Jump

All times are GMT -4. The time now is 18:19.