|
[Sponsors] |
February 19, 2003, 06:32 |
Mesh Problem
|
#1 |
Guest
Posts: n/a
|
How is it that I can have control it of the direction of the normal for each surface in ProAM? This in the case of me to have several sub-domains and to want to have controls it of the mesh, in other words, to have the mesh so much inside as well as among them. I have the box (static domain) and inside of this I have the cylinder (movable domain). Inside of the cylinder (movable domain) she i the candle. My problem i that PROAM makes the mesh among the box (static domain) and the cylinder (movable domain) but she doesn't of the between the cylinder and the candle. How i it that should proceed? Thank you goes your attention, good work.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D mesh problem | sphinx | FLUENT | 0 | July 24, 2008 12:26 |
Mesh problem? | Jake | FLUENT | 2 | March 26, 2008 18:05 |
Problem with mesh | msg30 | OpenFOAM Running, Solving & CFD | 2 | May 7, 2007 13:03 |
mesh problem in 3D | abdellah | FLUENT | 0 | March 15, 2005 04:30 |
CFX Mesh problem | Atit Koonsrisuk | CFX | 4 | October 5, 2004 08:14 |