|
[Sponsors] |
October 22, 2003, 07:57 |
pro*am issue
|
#1 |
Guest
Posts: n/a
|
Hi,
I am creating tetras in pro*am. But while creating subsurface it is giving proble. The subsurface is getting created above the geometry. Because of this the tetra generation batch run is coming out giving fatal error message that 'self intersecting surface' (surface check does not give any error of self intersecting surface) Has anybody faced this problem before? Please help. Thanks, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
y+ and y* issue | Freeman | FLUENT | 9 | December 6, 2017 11:46 |
Geometry Issue! | Mann | CFX | 2 | January 14, 2008 16:33 |
CHT issue | john | Siemens | 0 | May 10, 2004 03:26 |
pro*am issue | john | Siemens | 1 | March 18, 2004 15:51 |
CHT issue | carno | Siemens | 3 | September 23, 2003 01:30 |