|
[Sponsors] |
March 16, 2004, 05:37 |
heat transfer
|
#1 |
Guest
Posts: n/a
|
Hello,
I'm doing a two-layer simulation of a convective heat transfer problem. But the htran values are calculated very high (about 1000 W/m^2K), although my y+ values are smaller than 1. Hcoef looks fine (about 25W/m^2K). Is htran only calculated for models including wall functions? I have a similar problem with a low-Re-tubulence model. Thanks in advance, Peter |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Forced convection heat transfer in heat sink | Sidy | FLUENT | 1 | October 18, 2008 03:27 |
flow/heat transfer through heat sink (with fins)? | Pei-Ying Hsieh | Main CFD Forum | 1 | January 26, 2008 06:33 |
HEAT-TRANSFER & EXCHANGE HEAT MODEL Problems | Jordi | FLUENT | 1 | March 31, 2006 10:30 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Heat Transfer Coeff. at Heat Flux Boundary | Rushyen | CFX | 6 | January 18, 2001 05:09 |