|
[Sponsors] |
September 21, 2004, 04:03 |
StarCCM+ polyhedra cell generation
|
#1 |
Guest
Posts: n/a
|
Hello Everyone,
I know it is again a stupid question, but: how can I CREATE any mesh in starccm+ ? it seems that I have only the possibility of importing of an .ngeom file. But it is not what I would like to do, I would like to prepare everything from A to Z in starccm+ (and also try to generate this famous polyhedral mesh...) Could you help me, please? is there any other 'subtool' I should run? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Why Differences between tetrahedra polyhedra and prism mesh pipe flow computation with sonicLiquidFoam | chnrdu | OpenFOAM Running, Solving & CFD | 5 | May 7, 2018 03:23 |
Problems on Tetrahedra to Polyhedra using polyDualMesh on concave surface object | chnrdu | OpenFOAM Pre-Processing | 2 | July 18, 2009 12:58 |
How can i use Tpoly to obtain Polyhedra? | Murat | FLUENT | 1 | January 20, 2009 13:14 |
Vortex generation with starccm+ | Benony | Siemens | 0 | May 17, 2006 11:59 |
Ver3.22 trimmed cell generation | Jihwan | Siemens | 0 | November 12, 2004 01:20 |