|
[Sponsors] |
October 18, 2004, 04:55 |
quasi 2D slice in proam
|
#1 |
Guest
Posts: n/a
|
HI Experts!
Is there a way to create a 2d slice (one cell thick) in proam? because I am afraid that it will start growing mesh inside and away from the perpendicular shells (along z) it can produce more than desired 1 cell... I have already the surfaces describing my slice and my plan is: 1.create the mesh with proam (trimmed) this way I will obtain nicely meshed front face. 2.remove everything apart of this front face 3.extrude the front face. Isn't it a bit 'oversophisticated'??? I am afraid that I must have missed something in the manual... ps. does anyone have a template mesh for an octagonal crossection? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] Average of SLICE in Paraview | Maurice Waldner | ParaView | 6 | December 16, 2018 17:41 |
Averaging pMean by slice | cedric_duprat | OpenFOAM Post-Processing | 0 | September 19, 2008 10:10 |
Section Slice in ProStar | benbru | Siemens | 1 | February 8, 2008 15:59 |
Tecplot Slice | Alex | Tecplot | 2 | April 28, 2006 08:28 |
How to save only a slice,not the whole data? | leon | Siemens | 3 | August 25, 2005 10:55 |