|
[Sponsors] |
March 24, 2006, 04:23 |
spray and combustion with EGR
|
#1 |
Guest
Posts: n/a
|
I am running diesel spray and combustion model.Unpremixed/Diffusion, EBU LATCT. I tried to calculate NOx concentration with EGR rate 5%, 10%, 15% and 20%, setting respectively initial conditions for air with CO2 concentration. However, for all of these models, I get the same temperature and NOx values. I checked all time steps, but either the values are the same, or they differ very little. For example, if EGR is 20%, NOx reduction is supposed to be about 50%. But, I can not get even close to this fact. Perhaps, I need to use different model settings. Does anybody know this problem? Please advise.
Regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
help spray and combustion | Razio | FLUENT | 0 | March 16, 2008 18:45 |
diesel spray and combustion with EGR | usker | Siemens | 1 | May 16, 2007 04:34 |
spray and combustion with EGR | usker | Siemens | 0 | March 27, 2006 21:33 |
spray combustion | baskar | FLUENT | 2 | May 14, 2005 04:25 |
Spray combustion validation | David | FLUENT | 0 | December 20, 2004 12:51 |