|
[Sponsors] |
April 6, 2008, 07:13 |
subsurface failed
|
#1 |
Guest
Posts: n/a
|
hi all,
I want to generate a nice subsurface for my complex duct model. the subsurface has failed in some regions of my model where the angle between surface is lower ( i guess). but the surface elements are of good quality. it results in zero thickness subsurface. so it results in poor quality tetra. i would like to avoid that. is there any advanced options available in proam. I only want to use Method 8 since Method 4 fails in prevailing subsurface thickness everywhere. If anybody knows, please letme know. thanks please also have a look at the attached image. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
subsurface problem | raffap | Siemens | 0 | May 4, 2007 11:39 |
problem in generating subsurface in proam?? | Ramesh | Siemens | 3 | March 14, 2007 15:47 |
problem in genrating subsurface with proam | Mir | Siemens | 0 | January 24, 2005 08:49 |
proam -subsurface meshing | tak | Siemens | 3 | December 30, 2004 10:23 |
Subsurface limits | Carlos Saraiva | Siemens | 0 | January 23, 2003 08:36 |