|
[Sponsors] |
July 16, 2013, 14:02 |
surface repair problem
|
#1 |
New Member
shoumo
Join Date: Jun 2013
Posts: 16
Rep Power: 12 |
Hello every one. Hoping every one is doing fine. I am very new to star CCM+. I am trying to run a simulation using tornado vortex chamber. The details are shown in the figure. I try to build the geometry in Star CCM+ but when i repair the surface it showed me 576 pierced surface and 192 face proximity. If possible can any one help me with this problem? the radius of the cylinder is .4m and the inlet is .41m and side wall is 1.66 m.
Zoheb |
|
Tags |
repair surface, star ccm+ |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
free surface problem with capillary effect | rabbitmelon | CFX | 25 | August 16, 2013 03:05 |
Problem in specifying the boundary condition for tank's surface which is on fire | BHE | FLUENT | 1 | March 21, 2013 23:02 |
[ICEM] Problem making structured mesh on a surface | froztbear | ANSYS Meshing & Geometry | 4 | November 10, 2011 08:52 |
surface orentation problem in icemcfd | jeevan kumar | CFX | 0 | August 18, 2008 04:25 |
Surface orentation problem in icemcfd | jeevan kumar | CFX | 0 | August 13, 2008 01:54 |