|
[Sponsors] |
August 31, 2013, 10:26 |
residual above 1
|
#1 |
New Member
Join Date: Jul 2013
Posts: 6
Rep Power: 12 |
Dear all;
If the residual chart was above 1 (residual amount=100 in 10000 iteration), What conclusion can be made? Dose the model has a problem? |
|
September 2, 2013, 03:09 |
|
#2 |
Member
Roman
Join Date: Mar 2011
Posts: 46
Rep Power: 15 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Courant Number @ icoFoam | Artex85 | OpenFOAM Running, Solving & CFD | 11 | February 16, 2017 13:40 |
Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 13:12 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 08:35 |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 06:37 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 05:24 |