 |
 |
 |
|
|
|
[Sponsors] | ||||
February 20, 2017, 09:06
|
StarCCM+ on OpenSuse 42.1
|
#1 |
|
Member
Join Date: Aug 2014
Location: Germany
Posts: 77
Rep Power: 11  |
Hi,
I just wanted to know if anyone had experience of using StarCCM+ (version 10.06.009 or 11.04.010) on opensuse 42.1 ? The official website lists opensuse 13.2 under supported platforms, but no mention of 42.1. Does it mean I might have trouble using it on 42.1 ? If anyone have some experience related to this, please share. Regards, Harry |
|
|
|
|
|
April 1, 2017, 06:26
|
opensuse
|
#2 |
|
Member
allan thomson
Join Date: Mar 2009
Location: scotland
Posts: 45
Rep Power: 17 |
Worked fine for me. I didn't have any issues.
allan |
|
|
|
|
|
|
April 3, 2017, 04:27
|
|
#3 |
|
Member
Join Date: Aug 2014
Location: Germany
Posts: 77
Rep Power: 11 |
Thank you Allan, I had also installed already and it is working fin so far.
Thank you for your response. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OpenFOAM.org] OpenFOAM-2.4.0 Installation on OpenSUSE 42.1 | danobis | OpenFOAM Installation | 1 | November 20, 2016 11:42 |
| [OpenFOAM.org] OpenFOAM 2.4.x and OpenFOAM 3.0.x on openSUSE Leap 42.1 | cbcoutinho | OpenFOAM Installation | 7 | April 10, 2016 15:15 |
| [foam-extend.org] A smooth installation of foam-3.0-extend on OpenSUSE 13.1 64-bits | cookcaptain | OpenFOAM Installation | 7 | May 26, 2015 11:22 |
| importing cad geometry, starCCM 64bit?? | syd | STAR-CCM+ | 3 | March 30, 2010 07:17 |
| [Other] Problems with starccm mesh | AndTen | OpenFOAM Meshing & Mesh Conversion | 1 | February 23, 2010 04:43 |
1Likes
Linear Mode
