 |
 |
 |
|
|
|
[Sponsors] | ||||
August 27, 2020, 02:32
|
mass flow
|
#1 |
|
New Member
huang,wei-hsin
Join Date: Aug 2020
Location: TAIWAN,R.O.C.
Posts: 3
Rep Power: 6  |
How to get mass flow parameter in 2D nozzle exit ?
I try probe to detect,but nothing show on plots. |
|
|
|
|
|
September 4, 2020, 06:18
|
|
#2 |
|
Senior Member
Ping
Join Date: Mar 2009
Posts: 556
Rep Power: 20 |
not much detail given?
why not use the mass flow report on an inlet or outlet, since a probe will only show you the flow at one point across the 2d flow stream |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Issues on the simulation of high-speed compressible flow within turbomachinery | dowlee | OpenFOAM Running, Solving & CFD | 11 | August 6, 2021 07:40 |
| Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 17, 2020 00:44 |
| Mass flow rate history over solution step- rhoSimpleFoam | gian93 | OpenFOAM Post-Processing | 0 | December 8, 2019 11:20 |
| Inconsistencies in reading .dat file during run time in new injection model | Scram_1 | OpenFOAM | 0 | March 23, 2018 23:29 |
| Mass Flow Inlet | Pravir Kumar Rai | FLUENT | 0 | February 19, 2003 15:03 |
Linear Mode
