|
[Sponsors] |
October 8, 2020, 21:01 |
converging section CFD
|
#1 |
Member
Bernhard Stiehl
Join Date: Oct 2018
Posts: 30
Rep Power: 7 |
I am trying to set up a
combustor followed by a converging section followed by a relatively long straight pipe at near-sonic condition followed by a dump/expansion region attached downstream. The combustor is supposed to operate at pressure of 5atm, however I struggle to get the pressure set right. I am using mass flow inlets (conditions scaled so that they result in p=5atm) and pressure outlet (1atm) at the expansion region (external flow). Any advice how to get the pressure set correctly? What happens upon initializing is that pressure builds up at the converging sections, leading to overall pressure build-up in the combustor beyond 5atm. Thank you, Bernie |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 16:14 |
LiftDrag utility from v12 to v141 | cfdphil | OpenFOAM Running, Solving & CFD | 2 | December 5, 2007 05:49 |
ASME CFD Symposium, Atlanta, July 2001 | Chris R. Kleijn | Main CFD Forum | 0 | September 13, 2000 04:48 |
ASME CFD Symposium, Atlanta, July 2001 | Chris R. Kleijn | Main CFD Forum | 0 | August 21, 2000 04:49 |
Which is better to develop in-house CFD code or to buy a available CFD package. | Tareq Al-shaalan | Main CFD Forum | 10 | June 12, 1999 23:27 |