|
[Sponsors] |
|
April 28, 2021, 18:49 |
2D Waves load on a sea wall
|
#1 |
New Member
Richerd
Join Date: Apr 2021
Posts: 1
Rep Power: 0 |
Hello everyone, I hope everyone is keeping safe and healthy.
I've been struggling for quite some time with the software StarCCM+, I am in process of creating a simple 2D numerical model where a first-order wave hits a vertical seawall. So it will be a 2D simulation where the water wave would hit the wall however each time I run the simulation my the whole domain would be filled with water. I am using the Eulerian multiphase in order to create the waves with VOF Fluid. However even though I set the point on the water level to a value, the water always fills up the whole domain and then goes over the vertical seawall. On top of that is there any ways I can see the Dynamic Pressure as on the software I can only see the Static Pressure only. I hope anyone can help me with this issue. Everywhere I looked didn't have much help so I hoped I could get some sort of help. Hello everyone, I hope everyone is keeping safe and healthy. Kind regards. I attached some of the pictures of the simulation that I am getting, the wall is meant to hit the approximately half way the vertical seawall. |
|
Tags |
#cfd, #hydraulics, #starccm+, #vof |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 17, 2020 00:44 |
Enhanced Wall Treatment | paduchev | FLUENT | 24 | January 8, 2018 12:55 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 07:20 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 18:30 |
Wall functions | Abhijit Tilak | Main CFD Forum | 6 | February 5, 1999 02:16 |