 |
 |
 |
|
|
|
[Sponsors] | ||||
Problem with flows not being able to enter a tube |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 21, 2022, 14:11
|
Problem with flows not being able to enter a tube
|
#1 |
|
New Member
Hollis Williams
Join Date: Jan 2022
Posts: 16
Rep Power: 4  |
I have a box with an outlet at one end and four inlets into which I feed four different gases (two of the gases enter through large pipes with large mass flow rates and two of them enter through small pipes with small mass flow rates).
The problem I have is that the two gases going through the small pipe start to enter the box but then get suppressed by the gases with the larger mass flow rates which flood the box and are unable to proceed further (as shown in the attached image). Is there some kind of backflow going on? |
|
|
|
|
|
February 22, 2022, 00:31
|
|
#2 |
|
Senior Member
Lucky
Join Date: Apr 2011
Location: Orlando, FL USA
Posts: 5,682
Rep Power: 66 |
What is even being plotted? What even are the boundary conditions?
|
|
|
|
|
|
|
February 25, 2022, 06:02
|
|
#3 | |
|
Senior Member
Chaotic Water
Join Date: Jul 2012
Location: Elgrin Fau
Posts: 436
Rep Power: 17 |
Quote:
|
||
|
|
|
||
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Initialization with two different initial states-Shock tube problem.!!! | Vino | SU2 | 9 | August 3, 2022 12:20 |
| [ANSYS Meshing] Interface wall problem between outer tube face and external flow domain | Onurozcan | ANSYS Meshing & Geometry | 0 | February 21, 2016 07:47 |
| [ANSYS Meshing] Problem in Meshing a tube in tube Helical HX | Maradona | ANSYS Meshing & Geometry | 0 | August 4, 2014 07:50 |
| Shock Tube problem | mouna lamnaouer | FLUENT | 1 | September 22, 2011 12:47 |
| Need help in setting up a shock tube problem | kalee | FLUENT | 0 | November 2, 2007 14:11 |
Linear Mode
