|
[Sponsors] |
June 9, 2022, 12:53 |
Problems with y+ and residuals
|
#1 |
New Member
Katarina
Join Date: May 2022
Posts: 1
Rep Power: 0 |
Hi!
I am a student and I am writing a graduate thesis on the topic: resistance of the KCS ship. I'm new to CFD and i don't have much experience. When i run the simulation i notice huge y+ numbers on the upper part of the hull while at the lower part they seem good, except at the end of the rudder. Is it the fault of the bad mesh or is it something else? I'm posting a picture so you can see my problems. Thank you very much! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cannot find functionObject file residuals | vava10 | OpenFOAM Pre-Processing | 2 | November 14, 2020 12:21 |
Problems with residuals oscillations | spacecraft | STAR-CCM+ | 2 | September 13, 2010 08:57 |
problems with residuals in fluent. | Tan | FLUENT | 3 | February 10, 2009 10:05 |
Problems with residuals | Martin | CFX | 2 | January 2, 2007 22:10 |
Problems with residuals?? | Peter Kolb | FLUENT | 0 | November 29, 2000 03:48 |