|
[Sponsors] |
How to fix Mesh for the simulation to get accurate Lift and Drag |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 17, 2023, 13:21 |
How to fix Mesh for the simulation to get accurate Lift and Drag
|
#1 |
New Member
Namith
Join Date: May 2023
Posts: 6
Rep Power: 3 |
Dear Forum,
I am trying to simulate a rugby ball to generate the lift and drag forces and I am getting negative values for the forces and would request the forum on the way forward to fix the error. Computation power is limited and have to get results with coarse mesh. Base Size - 0.01 to 0.008 Target Surface Size - 0.01 to 0.008 Minimum Surface Size - 0.01 to 0.008 Surface Growth Rate - 1.2 Number of Prism Layers - 5 Prism Layer Stretching - 1.2 Prism Layer Total Thickness - 0.0343 Volume Growth Rate- 1.3 velocity - 20m/s |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Calculation of lift and drag coefficients on airfoil | CoolHersheys | OpenFOAM Post-Processing | 5 | September 27, 2021 06:04 |
How to not overwrite drag and lift coefficients after a simulation | Giovanni Trovato | FLUENT | 1 | August 1, 2018 00:31 |
Drag and lift calculation in Arbitrary Mesh Interface simulation | anon_q | OpenFOAM | 7 | April 22, 2018 13:24 |
wrong SU2 calculation for lift and drag coefficient for NAC4421 | mechy | SU2 | 7 | January 9, 2017 05:18 |
Mesh Grid Study - Result Tolerance - Lift, Drag, Moment. | Wingman | Main CFD Forum | 4 | November 14, 2016 16:50 |