 |
 |
 |
|
|
|
[Sponsors] | ||||
August 15, 2017, 11:08
|
FSI analysis
|
#1 |
|
Member
PENANG
Join Date: Aug 2017
Location: Malaysia
Posts: 40
Rep Power: 8  |
Hi, I am trying to analyse FSI over wing. I obtained a wing model in Solidworks by part design, importing NACA geometry and developing ribs, etc and then extruding a surface to cover them. But, after importing the geometry to ansys workbench, i have obtained two geometries, as inside solid part and surface. I am not able to obtain successful Boolean due to two different geometries. KINDLY CHECK ATTACHED IMAGE.
Any help will be highly appreciated. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Initializing transient analysis using static analysis in two-way FSI simulation | Daniel_Khazaei | ANSYS | 50 | September 12, 2017 10:56 |
| FSI analysis | Rana shaharyar | Main CFD Forum | 2 | May 16, 2017 14:14 |
| FSI Transient Thermal Analysis | Abduri | CFX | 1 | January 1, 2017 22:54 |
| Is it possible extract natural frequency from 2-way FSI analysis.?? | sreemvlk | ANSYS | 1 | July 24, 2014 09:21 |
| Need help on FSI analysis and Re-meshing Approach | khinthida2005 | CFX | 5 | September 4, 2009 07:56 |
Linear Mode
