Abaqus: Import Results in a new Model

Rudy994 · November 8, 2021, 16:03

Hello,

I would like to import the results, which are stress,strains and displacements from one Model into a second Model. The second Model is very similar to the first one. There are just some extra parts and interactions.

When the results are imported i would like to set them as initial state. Before the actual calculation starts, some parts of the second Model should be stressed already. Basically the results (stress,displacement..)of the first Model should be set as initial State of the second Model. the additional parts of the second model should not be loaded at this point.
They will be loaded within the first calculation Step.

I think it should be possible using predefined field--> initial field, but some how it doesnt work.

any help is appreciated. Thanks

JMcnetee · December 9, 2021, 12:28

Hi Rudi

Did you make any progress on this? I am wondering about the same kind of problem. How to export a deflected shape

GUANGZHONG · July 3, 2023, 09:32

Hi Rudy,
Have you solved this problem?

November 8, 2021, 16:03	Abaqus: Import Results in a new Model	#1
Rudy994 New Member Anonym Join Date: Nov 2021 Posts: 1 Rep Power: 0	Hello, I would like to import the results, which are stress,strains and displacements from one Model into a second Model. The second Model is very similar to the first one. There are just some extra parts and interactions. When the results are imported i would like to set them as initial state. Before the actual calculation starts, some parts of the second Model should be stressed already. Basically the results (stress,displacement..)of the first Model should be set as initial State of the second Model. the additional parts of the second model should not be loaded at this point. They will be loaded within the first calculation Step. I think it should be possible using predefined field--> initial field, but some how it doesnt work. any help is appreciated. Thanks

December 9, 2021, 12:28	Any progress	#2
JMcnetee New Member Jarlath Join Date: Apr 2018 Posts: 12 Rep Power: 8	Hi Rudi Did you make any progress on this? I am wondering about the same kind of problem. How to export a deflected shape

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[IHFOAM] The IHFOAM Thread	Phicau	OpenFOAM Community Contributions	392	September 8, 2023 18:10
Table bounds warnings at: END OF TIME STEP	CFXer	CFX	4	July 16, 2020 23:44
Validating the results of numerical modeling compared to the results of another model	ENG.AHMAD	FLUENT	0	June 22, 2020 16:49
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
simulation results for k-w model and SST model	Li	CFX	7	June 29, 2007 04:19

July 3, 2023, 09:32		#3
GUANGZHONG New Member guangzhong Join Date: Jul 2023 Posts: 1 Rep Power: 0	Hi Rudy, Have you solved this problem?