[RonSwanson]

Hello,

I have set up SU2 for parallel running, and have obtained faster convergence with the QuickStart NACA model supplied. However when I run my own case it is slower, requires more iterations and returns worse residuals (though still reasonable).

When I look at the flow contours they seem physical, with no distortions or jumps. However when I look at the Coefficient of Pressure and Friction over one of my surfaces there is a point of missing data where I assume the partion cuts through. I have pressure outlet and inlet BCs and I'm wondering whether there is a conflict with them.

My current simulation is implicit, I have tried to run Explicitly though I get a core dump error. I am using the supplied Metis. Is there anyway with SU2 to view the partions? and then control them manually such as specifying a plane to cut through?

Cheers,
Ross