 |
 |
 |
|
|
|
[Sponsors] | ||||
Fluent 2D Incorrect massflow using Tecplot 360 2017 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 12, 2017, 14:12
|
Fluent 2D Incorrect massflow using Tecplot 360 2017
|
#1 |
|
New Member
Paht Thai
Join Date: Jan 2017
Posts: 3
Rep Power: 9  |
I set up a simple 2D fluent simulation using workbench. I extracted the CAS and DAT files with the results. I then load the results using tecplot. It reads everything just fine except when you go into Perform Integration -> Calculate Massflow at the inlet and outlets, the values are completely wrong compared to using CFDPost to post process.
Has anyone experienced this? How do you overcome it? |
|
|
|
|
| Tags |
| 2d flow, fluent, tecplot |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problem in importing fluent case nad data files to tecplot | ganeshranakoti | Tecplot | 1 | March 5, 2013 16:59 |
| contours fluent ----->> tecplot | lbmagis | Tecplot | 3 | January 31, 2013 18:49 |
| CFX-Post and Tecplot 360 | Rogerio Fernandes Brito | CFX | 2 | September 28, 2008 14:45 |
| tecplot 360 vs. 10 compatibility | N.R. | Tecplot | 6 | December 12, 2007 13:23 |
| Exporting data to Tecplot 360 | Genesis | FLUENT | 2 | June 6, 2007 17:53 |
Threaded Mode
