 |
 |
 |
|
|
|
[Sponsors] | ||||
July 4, 2011, 16:29
|
Wing Meshing
|
#1 |
|
New Member
steve levitt
Join Date: Jun 2010
Location: UK
Posts: 9
Rep Power: 15  |
I have meshed a wing and winglet with tetra mesh, but the results from the winglet area are not accurate enough. I tried blocked Hexa meshing and again found the results from the winglet area are not accurate enough.
Is it possible to use a combination mesh of Hexa around the wing and winglet, then a layer of tetra meshing to expand towards the far field and then Hexa meshing in the far field? Any comments on how of where to proceed would be greatly appreciated. Steve |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wing meshing help...... | ACER | Main CFD Forum | 0 | January 31, 2011 18:20 |
| Wing meshing 3d..... | ACER | ANSYS Meshing & Geometry | 0 | December 28, 2010 20:15 |
| [GAMBIT] Meshing Complex Wing Shape | racerdude777 | ANSYS Meshing & Geometry | 1 | December 16, 2010 09:31 |
| Meshing for 3D wing with tubercle on the leading edge in GAMBIT | nvtrieu | FLUENT | 0 | August 14, 2010 10:13 |
| [ICEM] Problems about meshing the swept wing with cylinder end cap | kepeng | ANSYS Meshing & Geometry | 3 | June 15, 2010 05:21 |
Threaded Mode
