|July 4, 2011, 16:29||
Join Date: Jun 2010
Posts: 9Rep Power: 8
I have meshed a wing and winglet with tetra mesh, but the results from the winglet area are not accurate enough. I tried blocked Hexa meshing and again found the results from the winglet area are not accurate enough.
Is it possible to use a combination mesh of Hexa around the wing and winglet, then a layer of tetra meshing to expand towards the far field and then Hexa meshing in the far field?
Any comments on how of where to proceed would be greatly appreciated.
|July 5, 2011, 09:14||
Retired from CFD Online
Join Date: Mar 2009
Location: Ann Arbor, MI
Blog Entries: 1Rep Power: 39
Yes, very doable...
But there are lots of ways to get it done, most using either MultiZone or Merge Hexa and Tetra. You could even use a combination (MultiZone for the near field and then merge that with a Hexa far field...) Another option is to additionally convert the Tetra region to Hexa...
This first pic shows multizone (outside in, but inside out works too).
This next set is a merge between a tetra race car and a Hexa far field...
First the far field is meshed...
Then the car
Then merge and convert tetra to hexa...
There is a simple tutorial about merging hexa and tetra in a pipe. A slightly more advanced HVAC tutorial is also available. Try those and you should be on your way. ICEM CFD Hexa/Tetra merging is very powerful and robust if you follow the rules...
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wing meshing help......||ACER||Main CFD Forum||0||January 31, 2011 19:20|
|Wing meshing 3d.....||ACER||ANSYS Meshing & Geometry||0||December 28, 2010 21:15|
|[GAMBIT] Meshing Complex Wing Shape||racerdude777||ANSYS Meshing & Geometry||1||December 16, 2010 10:31|
|Meshing for 3D wing with tubercle on the leading edge in GAMBIT||nvtrieu||FLUENT||0||August 14, 2010 10:13|
|[ICEM] Problems about meshing the swept wing with cylinder end cap||kepeng||ANSYS Meshing & Geometry||3||June 15, 2010 05:21|