Symmetry Plane boundary conditions

March 16, 2004, 17:28

Should I use Symmetry condition for my SimP or better make it - wall - free slip? Also what is better for "ground plane"? I use make it free slip - wall but may be I should make it wall moving at same speed as "Inlet"? As in reality gound plane under race car is moving with about same speed as oncoming air....

Thank you Ted

March 17, 2004, 00:12

Symmetry is the better condition to use when you are running say 1/2 of the car. Use symmetry on the slice plane through the car.

You are correct about the ground. There should be a minimal boundary layer coming up to the car. You can use a moving no-slip wall to simulate it.

Neale

March 16, 2004, 17:28	Symmetry Plane boundary conditions	#1
Tudor Miron Guest Posts: n/a	Should I use Symmetry condition for my SimP or better make it - wall - free slip? Also what is better for "ground plane"? I use make it free slip - wall but may be I should make it wall moving at same speed as "Inlet"? As in reality gound plane under race car is moving with about same speed as oncoming air.... Thank you Ted

March 17, 2004, 00:12	Re: Symmetry Plane boundary conditions	#2
Neale Guest Posts: n/a	Symmetry is the better condition to use when you are running say 1/2 of the car. Use symmetry on the slice plane through the car. You are correct about the ground. There should be a minimal boundary layer coming up to the car. You can use a moving no-slip wall to simulate it. Neale

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Domain Imbalance	HMR	CFX	5	October 10, 2016 05:57
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Setting turbulent plane poiseuille model to periodic boundary conditions.	QBeast	FLUENT	0	July 17, 2011 10:08
[Gmsh] Import problem	ARC	OpenFOAM Meshing & Mesh Conversion	0	February 27, 2010 10:56
Boundary Conditions	Jan Ramboer	Main CFD Forum	11	August 16, 1999 08:59