|
[Sponsors] |
November 3, 2023, 10:07 |
volume meshing by layering alwayse failed.
|
#1 |
New Member
Sheldon Lee
Join Date: May 2014
Location: On the moon.
Posts: 11
Rep Power: 12 |
----------------------+
meshing | inner side | | ----------------------+ I always meet the above type of geometry, an narrow, inward chamber. When I use auto layers to generate boundary layer mesh (3D) , the top_cap usually collides with itself, and the meshing is failed. Is there a possible way to make the collided top_cap merge and auto fill the 3D holes? thanks in advance. |
|
Tags |
layers |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
Volume 1 has invalid topology for mapped brick meshing | georgewar | ANSYS | 0 | July 24, 2011 16:02 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |