 |
 |
 |
|
|
|
[Sponsors] | ||||
June 6, 2012, 15:36
|
Export Geometry in BladeGen
|
#1 |
|
Member
Paulo
Join Date: Jun 2011
Posts: 34
Rep Power: 16  |
I'm quite new in BladeGen and I don't know if here is a right place to post it, but i didnt find any forum specific in BladeGen. So, i made a Turbine in BladeGen and when i export to ICEMCFD or DesignModeler the Solid volume all blades were exported but the volume of fluid is only of one blade. So, how could i export geometry of the volume of fluid of all blades?
Thanks |
|
|
|
|
|
June 13, 2012, 07:50
|
|
#2 |
|
New Member
kadir
Join Date: Oct 2011
Posts: 1
Rep Power: 0 |
Hi, Bladegen cannot create flow zone for all blades, but you can easily do it in design modeller
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] How to export geometry from icem | Nick R | ANSYS Meshing & Geometry | 3 | November 10, 2012 04:20 |
| How to analyse a assembly geometry by use of the ANSYS-ICEM ? | feixiangniao | CFX | 3 | April 2, 2010 01:10 |
| [Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 05:53 |
| [ICEM] Ship Hull imported geometry | nuovodna | ANSYS Meshing & Geometry | 0 | February 25, 2010 11:09 |
| vitual _ real | deneb | FLUENT | 3 | January 22, 2007 05:31 |
Linear Mode
