|
[Sponsors] |
October 30, 2012, 07:19 |
sweepable bodies & meshing
|
#1 |
Member
Sandeep
Join Date: Oct 2012
Location: India
Posts: 51
Rep Power: 13 |
Hi ,
i have shell body , of 1 mm thickness i want to make it sweep-able so that i can apply 'sweep-able mesh' method. As a whole the body is not sweep-able, so i have sliced it into many parts (to create a multi-body part) , now this is what i observe: individually , the smaller bodies (created as a result of slice)are shown as 'sweep-able' in ANSYS Mesher, BUT when i unsupress the whole body in DM and take it to mesher , many bodies which were sweep-able individually , now have become unsweep-able. Why is it happening and where i have to check it ..something wrong at the body-interfaces ? Thanks Sandeep |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shared surface between bodies for better meshing? | alxe | ANSYS Meshing & Geometry | 5 | August 18, 2011 11:52 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |