|
[Sponsors] |
[ANSYS Meshing] Automasing the sequential process of meshing different parts |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 5, 2012, 07:44 |
Automasing the sequential process of meshing different parts
|
#1 |
New Member
Juan Campos
Join Date: Oct 2010
Posts: 12
Rep Power: 15 |
Hi everybody,
I am dealing with a CFX aerodynamics simulation. The geometry has two very different zones. I was trying with different methods and configurations and I get the best results of the mesh, meshing the two zones separately: I supress one part and meshing, then unsupress+supress the other part and meshing, and It works very well. The problem is that I'm doing this process manually and I want to parametrize the model and that is going to required many time. Is there some way to do this manual process automatically? thank you very much in advance, best regards |
|
Tags |
mesh, multiparts |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
duration of meshing process | stefank | ANSYS Meshing & Geometry | 10 | November 17, 2015 17:12 |
[Netgen] meshing process stops (after surf meshing?) | vaina74 | OpenFOAM Meshing & Mesh Conversion | 5 | May 27, 2011 02:32 |
[ICEM] Problem vt unstructured meshing | raghav | ANSYS Meshing & Geometry | 1 | October 8, 2010 12:21 |
[ICEM] Basic meshing doubt | vishnukmd7 | ANSYS Meshing & Geometry | 2 | September 24, 2010 01:36 |
Meshing 3D AHU room | khimkhim | ANSYS Meshing & Geometry | 3 | November 4, 2009 11:26 |