|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Raef
Join Date: Nov 2011
Posts: 16
Rep Power: 15 ![]() |
Hello,
I am having a trouble meshing the bend in a pipe , every time I mesh the pipe i divide it into 3 section but one of the section looks bad after meshing where cross connected lines appear on the corner , please check the image and if you have any advice I would be grateful to read it . Thank you corner.jpg pipe.jpg |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Senior Member
|
could you plesae upload the geometry file. let me have a try
![]() |
|
![]() |
![]() |
![]() |
![]() |
#3 |
Senior Member
François Grégoire
Join Date: Jan 2010
Location: Canada
Posts: 392
Rep Power: 18 ![]() |
I'm not an expert, but at first it looks to me as if your 'Edge-to-Curve-Associations' are not right. In the model tree under blocking, right-click 'Edges' and activate 'Show Association', you'll see if your associations are right.
|
|
![]() |
![]() |
![]() |
![]() |
#4 |
Senior Member
Christoph
Join Date: May 2011
Location: Germany
Posts: 182
Rep Power: 18 ![]() |
||
![]() |
![]() |
![]() |
Tags |
icem, meshing, pipe bend, problem |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Simple pipe meshing - problems with y+ in CFX | Keizers | ANSYS Meshing & Geometry | 23 | January 15, 2015 08:00 |
[ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 04:25 |
[ICEM] ICEM Hexa Meshing Automation | Haasini | ANSYS Meshing & Geometry | 1 | April 24, 2012 22:46 |
[GAMBIT] GAMBIT Meshing of Pipe with Holes Perpendiculer to Flow Stream | rocketman1151 | ANSYS Meshing & Geometry | 7 | November 30, 2011 02:39 |
ICEM meshing question | gsbhatia89 | ANSYS Meshing & Geometry | 5 | June 14, 2010 08:24 |