|
[Sponsors] |
[DesignModeler] how to subtract a surface body from a solid body? |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
yahya
Join Date: Jul 2012
Posts: 43
Rep Power: 13 ![]() |
How to subtract a surface body that lies inside a solid body from the whole solid body..when I try to do this I get the following error: "Error: Operation would result in non-manifold bodies."
Any suggestions? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Member
yahya
Join Date: Jul 2012
Posts: 43
Rep Power: 13 ![]() |
any help guys?
|
|
![]() |
![]() |
![]() |
![]() |
#3 |
Senior Member
|
Well, a surface body has no volume, so you aren't really subtracting anything. More information might help us help you
|
|
![]() |
![]() |
![]() |
![]() |
#4 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 ![]() |
with easy geometries you can try surface from edge or face (i don't remember if face exists...) and then i sew these surfaces together. i have never tried that on round geometries like a sphere tough...
|
|
![]() |
![]() |
![]() |
![]() |
#5 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 ![]() |
here something you can also do, it worked for me once, export your geometry in STEP file.
open it in ICEM CFD, export it again, then import it in designmodeler... |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
[DesignModeler] Merge Surface Body and Solid Body | prikeyma | ANSYS Meshing & Geometry | 5 | April 16, 2015 07:01 |
[DesignModeler] Generating solid body between two bodies. | yshi095 | ANSYS Meshing & Geometry | 8 | October 1, 2013 06:07 |
Particle attachment to solid surface wall | Ashraf | STAR-CCM+ | 1 | August 4, 2012 07:36 |
solid edge problem....can you help? | cindy | Main CFD Forum | 3 | April 5, 2004 13:43 |