|
[Sponsors] |
[ANSYS Meshing] How to mesh an orifice in ICEM |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 28, 2013, 05:25 |
How to mesh an orifice in ICEM
|
#1 |
Senior Member
|
Hi,
I am a new user of ICEM. I wanto to mesh an hydraulic orifice (Hex mesh). Can anyone suggest some tutorial that I can follow or just write what is the procedure that I need to carry out ? Here is the geometry of my case Thanks Marco |
|
January 28, 2013, 08:32 |
|
#2 | |
Member
Smaras
Join Date: Sep 2012
Location: Germany
Posts: 78
Rep Power: 13 |
Quote:
I would prefer doing this tutorial first. It will help you a lot ANSYS ICEM CFD HEXA 3D Elbow Tutorial You can get the tutorials files from Ansys customer portal. Regards, Smaras |
||
January 28, 2013, 09:27 |
|
#3 |
Senior Member
|
Hi Smaras,
I have already had a look to this tutorial but it did not help me so much. What I have done is : -create parts (inlet, outlet, wall and two symmetry plane) -create a block -create an o-grid -try to split block (without good results) is it right?? Thanks Marco |
|
February 8, 2013, 02:52 |
|
#5 |
Senior Member
|
Hi Ali,
sorry for the late response! I got my mesh with ICEM !! Thanks to your link too! So ..THX Best Regards Marco |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
[ANSYS Meshing] Question about ICEM mesh output to CFX | lnk | ANSYS Meshing & Geometry | 0 | July 27, 2012 15:39 |
ICEM Edit Mesh | blackbody | ANSYS Meshing & Geometry | 3 | March 8, 2010 02:49 |
Boddy fitted Hexcore Mesh in ICEM Cfd | Mitch | CFX | 0 | December 29, 2008 06:07 |
ICEM clustering of mesh points and multiple edges | webhaw | CFX | 4 | July 25, 2007 16:29 |