[Teradil]

Hi all,

i have a problem with my blocking strategy. Pls give me some advise to improve my angle-quality.

I have a complex flow channel with 6 bores at their outer radius. I want to have a o-grid in my bores - but without going it far in my flow channel.
My current solution is shown in my paint draw.
The problem is that ICEM is going to project the ogrid to the block above my bore.. The block above is a mapped circle. - But it is possible.. because i have 6 bores in a row.. and the inner 4 are ok. There ICEM only projects the ogrid to 2 sides and my angles are ok.

So, i'm searching for a function to change the projection-typ of the inner ogrid-block. I hope you can help me without my real geometry.

Thats a lot!

Jens