|
[Sponsors] |
[DesignModeler] how to add aonther part in gemotry workbench |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 16, 2013, 08:06 |
how to add aonther part in gemotry workbench
|
#1 |
New Member
Alireza
Join Date: May 2013
Posts: 14
Rep Power: 13 |
Hi,
I want to simulate two cylinders with two bricks inside. one of the cylinder together with brick is stationary and the other is rotary. They are adjacent to each other. To have a better insight, I have attached a section of the problem (the wire frame is selected to show the brick inside). To the present time, I drew only the stationary part. It is required that the rotary cylinder is considered as an another body. The face split is only for surfaces. do you know other function to do a for volume part? I would be appreciated if you help me. Alireza |
|
May 17, 2013, 13:39 |
|
#3 | |
New Member
Alireza
Join Date: May 2013
Posts: 14
Rep Power: 13 |
Quote:
Actually the problem was that i didn't active the frozen section while extruding the surface!! it works now. can u plz tell me what freezing a body means in Ansys?!! can it be troublesome in meshing? Thanks in advance Alireza |
||
May 17, 2013, 14:55 |
|
#4 | |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 29 |
From the ansys documentation:
Quote:
|
||
July 27, 2015, 11:22 |
Creating separated body parts from an imported geometry
|
#5 |
New Member
Heather Smith
Join Date: Oct 2014
Posts: 4
Rep Power: 11 |
Hi all,
I have imported a geometry from solidworks and it is one body part in ANSYS transient structural. I want to create separated body parts from this geometry (select certain parts of the geometry and create a separated body). Any suggestions on how this can be done? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Identical meshes in symmetric bodies in multibody part. | aarvay | ANSYS Meshing & Geometry | 2 | May 11, 2012 11:15 |
icem hexa - load different blockings for each part of geometry??? | Catthan | ANSYS Meshing & Geometry | 2 | May 28, 2010 11:27 |
Temperature contour as thermal condition in Workbench? | nuothe11th | ANSYS | 0 | April 23, 2010 12:11 |
Properly using symmetry with both CFX and ANSYS workbench for a FSI analysis, help! | Cirion0000 | CFX | 0 | July 6, 2009 14:26 |
Can we add extra solid mesh part to the analsis? | Farhath Alam | FLUENT | 0 | December 22, 2006 02:41 |